From 6a1503e9db4bb9b5e6bb47f298eb3677c0673bc4 Mon Sep 17 00:00:00 2001 From: Rizwan Qureshi Date: Thu, 16 Mar 2017 13:19:22 +0530 Subject: google/poppy: Use rt5663 interrupt as GpioInt instead of PIRQ The kernel driver for rt5663 expects to get an interrupt on both a rising and falling edge, and using a legacy interrupt doesn't provide that flexibility. Instead configure this pin as a GPIO and use the interrupt through the GPIO controller. This allows using GpioInt() with ActiveBoth setting and results in correct operation of the headset jack. This is a clone of Duncan's patch for eve at I6f181ec560fe9d34efc023ef6e78e33cb0b4c529 BUG=none BRANCH=none TEST=test on poppy that headset jack detect is read properly at boot, and that plugging in and removing both generate a single interrupt event in the driver. Change-Id: I4aaa4164cb277a98ab5d5f033632f5e16bfb779e Signed-off-by: Rizwan Qureshi Signed-off-by: Duncan Laurie Reviewed-on: https://review.coreboot.org/18853 Tested-by: build bot (Jenkins) Reviewed-by: Aaron Durbin --- src/mainboard/google/poppy/devicetree.cb | 2 +- src/mainboard/google/poppy/gpio.h | 3 +-- 2 files changed, 2 insertions(+), 3 deletions(-) (limited to 'src/mainboard') diff --git a/src/mainboard/google/poppy/devicetree.cb b/src/mainboard/google/poppy/devicetree.cb index bdf16e6456..fc639677fc 100644 --- a/src/mainboard/google/poppy/devicetree.cb +++ b/src/mainboard/google/poppy/devicetree.cb @@ -234,7 +234,7 @@ chip soc/intel/skylake register "hid" = ""10EC5663"" register "name" = ""RT53"" register "desc" = ""Realtek RT5663"" - register "irq" = "ACPI_IRQ_LEVEL_LOW(GPP_D9_IRQ)" + register "irq_gpio" = "ACPI_GPIO_IRQ_EDGE_BOTH(GPP_D9)" register "probed" = "1" device i2c 13 on end end diff --git a/src/mainboard/google/poppy/gpio.h b/src/mainboard/google/poppy/gpio.h index e83ff8142c..bd452af68f 100644 --- a/src/mainboard/google/poppy/gpio.h +++ b/src/mainboard/google/poppy/gpio.h @@ -129,8 +129,7 @@ static const struct pad_config gpio_table[] = { NF1), /* ISH_SENSOR */ /* ISH_I2C1_SDA */ PAD_CFG_NC(GPP_D7), /* ISH_I2C1_SCL */ PAD_CFG_NC(GPP_D8), -/* ISH_SPI_CS# */ PAD_CFG_GPI_APIC(GPP_D9, NONE, - PLTRST), /* HP_IRQ_GPIO */ +/* ISH_SPI_CS# */ PAD_CFG_GPI(GPP_D9, NONE, PLTRST), /* HP_IRQ_GPIO */ /* ISH_SPI_CLK */ PAD_CFG_GPO(GPP_D10, 1, DEEP), /* SPKR_RST_L */ /* ISH_SPI_MISO */ PAD_CFG_GPI_APIC(GPP_D11, NONE, PLTRST), /* SPKR_INT_L */ -- cgit v1.2.3