From 5e3854ae7b585d798974eb649ca9e6088b54debf Mon Sep 17 00:00:00 2001 From: Maxim Polyakov Date: Sun, 16 May 2021 17:43:00 +0300 Subject: kontron/mal10: Set up GPIOs in CPLD/EC The COMe module connector implements 8 GPIO lines from the CPLD/EC pins. Use the Kempld GPIO driver[1] to configure these pins in accordance with the COM Express Module Base Specification [2]. TEST = Set different logic states for the pin configured as outputs and check them with an oscilloscope. [1] CB:47595 , Change-Id: Id767aa451fbf2ca1c0dccfc9aa2c024c6f37c1bb [2] page 79-81, PICMG (R) COM.0 Revision 3.0 COM Express (R) Base Specification - March 31, 2017. Change-Id: I7d354aa32ac8c64f54b2bcbdb4f1b8915f55264e Signed-off-by: Maxim Polyakov Reviewed-on: https://review.coreboot.org/c/coreboot/+/54380 Reviewed-by: Angel Pons Reviewed-by: Nico Huber Tested-by: build bot (Jenkins) --- src/mainboard/kontron/mal10/variants/mal10/devicetree.cb | 11 +++++++++++ 1 file changed, 11 insertions(+) (limited to 'src/mainboard/kontron/mal10') diff --git a/src/mainboard/kontron/mal10/variants/mal10/devicetree.cb b/src/mainboard/kontron/mal10/variants/mal10/devicetree.cb index 1421cb7905..5c89a644d9 100644 --- a/src/mainboard/kontron/mal10/variants/mal10/devicetree.cb +++ b/src/mainboard/kontron/mal10/variants/mal10/devicetree.cb @@ -74,6 +74,17 @@ chip soc/intel/apollolake device generic 1.0 on # I2C register "i2c_frequency" = "KEMPLD_I2C_FREQ_FAST_MODE_400KHZ" end + device gpio 0 on # GPIO + # The connector implements 8 GPIO lines only + register "gpio[0]" = "KEMPLD_GPIO_INPUT" + register "gpio[1]" = "KEMPLD_GPIO_INPUT" + register "gpio[2]" = "KEMPLD_GPIO_INPUT" + register "gpio[3]" = "KEMPLD_GPIO_INPUT" + register "gpio[4]" = "KEMPLD_GPIO_OUTPUT_LOW" + register "gpio[5]" = "KEMPLD_GPIO_OUTPUT_LOW" + register "gpio[6]" = "KEMPLD_GPIO_OUTPUT_LOW" + register "gpio[7]" = "KEMPLD_GPIO_OUTPUT_LOW" + end end end # LPC device pci 1f.1 on # SMBUS -- cgit v1.2.3