summaryrefslogtreecommitdiff
path: root/src/mainboard/siemens/mc_apl1
AgeCommit message (Expand)Author
2022-06-20soc/intel/apollolake: Hook Up SataPortEnable to devicetreeSean Rhodes
2022-05-18intel/common/block: Provide RAPL and min clock ratio switches in commonUwe Poeche
2022-04-21tpm: Refactor TPM Kconfig dimensionsJes B. Klinke
2022-03-07src: Make PCI ID define names shorterFelix Singer
2022-02-22mb/siemens/mc_apl2: Enable PCI device for I2C bus 0Werner Zeh
2022-02-12mb/siemens/mc_apl{2,4,5,6}: Enable recovery MRC cacheWerner Zeh
2022-02-01mb/siemens/{mc_apl1,...,mc_apl6}: Disable SATA ALPM supportMario Scheithauer
2021-11-04treewide: Replace bad uses of `find_resource`Angel Pons
2021-07-26mb/*: Specify type of `VARIANT_DIR` onceAngel Pons
2021-07-26mb/*: Specify type of `FMDFILE` onceAngel Pons
2021-07-26mb/*: Specify type of `DEVICETREE` onceAngel Pons
2021-07-26mb/*: Specify type of `MAINBOARD_PART_NUMBER` onceAngel Pons
2021-07-26mb/*: Specify type of `MAINBOARD_DIR` onceAngel Pons
2021-07-23mb/siemens/mc_apl{1,2,3,5,6}: Use PCI_ALLOW_BUS_MASTER_ANY_DEVICEWerner Zeh
2021-07-21mb/siemens/mc_apl{1,2,3,5,6}: Set PCI bus master bit only if allowedWerner Zeh
2021-06-04mb/siemens/mc_apl2: Disable unused I2C controllersWerner Zeh
2021-06-04mb/siemens/mc_apl{1,2,3,5,6}: Provide I2C timings for 400 kHzWerner Zeh
2021-05-30mb/siemens/mc_apl{1,2,3,5,6}: Disable ACPI-support for RX6110Werner Zeh
2021-05-30mb/siemens/mc_apl1: Move gpio.c from baseboard to mc_apl1Mario Scheithauer
2021-05-30mb/siemens/{mc_apl2,...,mc_apl6}: Do early UART pad configurationMario Scheithauer
2021-05-02mb/siemens/mc_apl{1,2,3,5,6}: Tune I2C frequencyWerner Zeh
2021-02-16mb/siemens/mc_apl1/variants/mc_apl2/mainboard.c: Clean includesElyes HAOUAS
2021-02-15src/mb: Remove unused <console/console.h>Elyes HAOUAS
2021-02-10mb/siemens/mc_apl2: Switch I2C bus for RX6110SAMario Scheithauer
2021-02-02mb/siemens/mc_apl1: do UART pad configuration at board-levelMichael Niewöhner
2021-01-27ACPI: Add top-level ASLKyösti Mälkki
2021-01-20mb/siemens/{mc_apl1,...,mc_apl6}: Configure FSP-S UPDsMario Scheithauer
2021-01-15mb/siemens/mc_apl1: do LPC/eSPI pad configuration at board-levelMichael Niewöhner
2020-11-30mb/siemens/mc_apl1: Deduplicate wait_for_legacy_dev()Angel Pons
2020-11-30mb/siemens/mc_apl1: Simplify is_mac_adr_valid() logicAngel Pons
2020-11-30drivers/intel/i210: Define MAC_ADDR_LENAngel Pons
2020-11-30mb/siemens/mc_apl1/mainboard.c: Refactor loop bodyAngel Pons
2020-11-23mb/siemens/mc_apl1: Use `pci_or_config16` functionAngel Pons
2020-10-13{src/mb,util/autoport}: Use macro for DSDT revisionElyes HAOUAS
2020-10-05mb/siemens/mc_apl6: Enable eMMCMario Scheithauer
2020-09-19apollolake boards: Enable CSE in devicetreeSubrata Banik
2020-09-10mb/siemens/mc_apl2/gpio: Fix code styleMaxim Polyakov
2020-09-10mb/siemens/mc_apl2/gpio: Undo set DRIVER for GPOMaxim Polyakov
2020-09-09apollolake: Define MAX_CPUS at SoC scopeAngel Pons
2020-09-09apollolake: Limit MAX_CPUS to 4Angel Pons
2020-07-09mb/siemens/mc_apl1: Use OPCODE menu set up of fast SPI driverWerner Zeh
2020-06-30src: Remove whitespaces before tabsElyes HAOUAS
2020-06-19Kconfig: Escape variable to accommodate new Kconfig versionsPatrick Georgi
2020-05-11treewide: Remove "this file is part of" linesPatrick Georgi
2020-05-02acpi: Move ACPI table support out of arch/x86 (3/5)Furquan Shaikh
2020-04-04mainboard/siemens: Use SPDX for GPL-2.0-only filesAngel Pons
2020-03-31security/vboot: Decouple measured boot from verified bootBill XIE
2020-03-18mainboard/[^a-p]*: Remove copyright noticesPatrick Georgi
2020-01-10src: Remove blank acpi_tables source filesKarthikeyan Ramasubramanian
2019-12-31mb/**/dsdt.asl: Remove outdated sleepstates.asl commentAngel Pons
2019-12-21mb/**/dsdt.asl: Remove "Some generic macros" commentAngel Pons
2019-12-20src/mainboard: Remove unused '#include <device/pci.h>'Elyes HAOUAS
2019-11-23Kconfig: comply to Linux 5.3's Kconfig language rulesPatrick Georgi
2019-11-12src/mainboard/siemens: Use PTN3460 chip driverUwe Poeche
2019-11-12mb/siemens/mc_apl6: Enable VT-d featureWerner Zeh
2019-11-11mb/siemens/mc_apl6: Add TPM to devicetreeWerner Zeh
2019-11-11mb/siemens/mc_apl6: Enable SDHCI and disable eMMC controllerWerner Zeh
2019-11-11mb/siemens/mc_apl6: Adjust clock lines used on PCIe-2-PCI bridgeWerner Zeh
2019-11-11mb/siemens/mc_apl6: Enable VBOOT per defaultWerner Zeh
2019-11-11mb/siemens/mc_apl6: Add new mainboard based on mc_apl3Werner Zeh
2019-11-01soc/intel/{IA-CPU/SOC}: Move sleepstates.asl into southbridge/intel/common/acpiSubrata Banik
2019-10-24mb/siemens/{mc_apl1, mc_bdx1}: Remove offsets from flashmap filesWerner Zeh
2019-10-18mb/siemens/mc_apl{3,5}: Remove __weak symbol from GPIO functionsWerner Zeh
2019-09-25mb/siemens/mc_apl1: Sort the names of all variant mainboardsWerner Zeh
2019-09-25mb/siemens/mc_apl{2,4,5}: Enable VBOOTWerner Zeh
2019-09-05mb/siemens/mc_apl5: Disable IGD if no EDID data availableMario Scheithauer
2019-07-18mb/siemens/{mc_apl1,...,mc_apl5}: Fix GPIO settingsMario Scheithauer
2019-07-18mb/siemens/mc_apl1: Disable all UHS-I SD-Card speed modesMario Scheithauer
2019-07-12mb/siemens/mc_apl3: Enable LPSS UART 1Mario Scheithauer
2019-07-11mb/siemens/{baseboard,mc_apl3,mc_apl4,mc_apl5}: Fix GPIO_168Mario Scheithauer
2019-07-11mb/siemens/{mc_apl1,...,mc_apl5}: Reduce eMMC bus speed modeMario Scheithauer
2019-06-21siemens/mc_apl5: Change PTN interface settingsMario Scheithauer
2019-06-21siemens/mc_apl5: Enable TPM supportMario Scheithauer
2019-06-06siemens/mc_apl5: Add own GPIO tableMario Scheithauer
2019-05-29src/mainboard: Add missing 'include <types.h>'Elyes HAOUAS
2019-05-06mb/siemens/mc_apl2: Limit SD-Card speed to DDR50Werner Zeh
2019-04-15mb/siemens/mc_apl4: Remove usage of external RTCWerner Zeh
2019-04-15mb/siemens/mc_apl1: Enable HDA in devicetree for all mainboard variantsWerner Zeh
2019-04-08siemens/mc_apl5: Remove reduced clock rate for I2C0Mario Scheithauer
2019-04-04siemens/mc_apl4: Provide CLK on APL Pin PMU_SUSCLKUwe Poeche
2019-03-21mb/siemens/mc_apl1: use comment in Kconfig.nameThomas Heijligen
2019-03-15mb/mc_apl1/variants/mc_apl5: Drop unused '#include <lib.h>'Elyes HAOUAS
2019-03-06mb/siemens/{mc_apl1,mc_tcu3}: Fix typo on "Display"Elyes HAOUAS
2019-03-04device/mmio.h: Add include file for MMIO opsKyösti Mälkki
2019-03-04arch/io.h: Add missing includesKyösti Mälkki
2019-03-01device/pci: Fix PCI accessor headersKyösti Mälkki
2019-02-13siemens/mc_apl4: Enable HW SPI TPM on mainboard mc_apl4Uwe Poeche
2019-02-13siemens/mc_apl2: Remove double entry from devicetreeMario Scheithauer
2019-02-05mb/siemens/mc_apl1: Enable VTD for mc_apl2 and mc_apl5Werner Zeh
2019-01-30siemens/mc_apl2: Change SERIRQ modeMario Scheithauer
2019-01-30siemens/mc_apl2: Correct whitespace of devicetreeMario Scheithauer
2019-01-30siemens/mc_apl2: Activate TPM supportMario Scheithauer
2019-01-16siemens/mc_apl4: Change UART_FOR_CONSOLE indexMario Scheithauer
2019-01-11siemens/mc_apl1: Use INTEL_LPSS_UART_FOR_CONSOLEMario Scheithauer
2018-12-17siemens/mc_apl4: Enable RTC RX6110SA on this mainboardUwe Poeche
2018-12-17siemens/mc_apl4: Enable LVDS Display on mc_apl4Uwe Poeche
2018-12-17siemens/mc_apl4: Add GPIO configurationUwe Poeche
2018-11-30cpu/intel/common: Use a common acpi/cpu.asl fileArthur Heymans
2018-11-29siemens/mc_apl5: Disable PCI clock outputs on XIO bridgesMario Scheithauer
2018-11-29siemens/mc_apl5: Set bus master bit for on-board PCI deviceMario Scheithauer
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-30 15:50:16 +0000